Video Transcript
Hi, welcome to Matchmaster for the best. Today we are going to talk to you about the 05MM-WP77, slim line single gang wall plate.
The WP77 comes pre-assembled, with fold out locking clips on the side of the plate pre-installed, a single mech port and a neat and tidy, slim line plate cover.
The wall plate has been designed so you do not require any additional mounting accessories due to the use of the floating clips for securing to the wall sheet.
The W P seventy seven is part of a suite of wall plates all featuring the same fold out wall clip design, made available in multiple formats to meet your needs.
Slim line cable management plate with brush cover, slim line single and dual gang grid plates, standard profile fixed free to air and satellite T V options, and standard profile single, dual and four gang grid plates plus a combination dual gang grid with cable management.
Now, let’s take you through the installation of the plates, it’s a very simple one piece design, all you need to in the way of tools to set this up are: Phillips head screwdriver, pencil, wall plate level and a wall sheet cutting tool.
Okay let us get started.
The wall cutout diameter for the wall plate is one hundred and fifteen millimeters wide by fifty five millimeters high so we will need to use a suitable cutting tool to create an opening in the wall for the plates to be installed.
Once we have selected our installation location, we must first check the location using a stud finder, metal detector or electrical detector and make sure there are no obstructions behind before making any cuts.
Once confirmed, it is safe to cut in this location, we need to mark out on the wall the cutout.
You can use the supplied cutout template to trace around then ensure the horizontal trace lines are level.
Now we can go ahead and make our cut using our cutting tool, be careful not to force the tool too quickly through the wall, just in case there is anything further back in the wall, that you haven’t detected.
Now we take our wall plate, which is ready to install, and we pop the slim line cover off so we can access the screw points.
Before fitting into the wall cutout, please ensure to connect your suitable mech of choice with terminated cable and make sure it is securely seated.
Now place the wall plate in the cutout, gently pressing into the wall sheet allowing the stabilizer fins to seat into the wall while ensuring the plate is still level, if you are fitting to a harder sheet surface, you may need to make small cuts to allow the stabilizer fins to seat properly and allow the plate to fit flush to the wall surface.
Now hold the unit in the location, take your Phillips head screwdriver, just give it a few winds anticlockwise first to unwind and prepare the locking clip, then wind it in the clockwise direction to seat the locking clip in position and secure the plate to the wall, continue this step on the other fastening screw.
Now place the cover plate over and clip securely into place.
And that is it, the W P seventy seven wall plate is now installed and secure leaving a neat and tidy finish.
For further information, please call us at one eight hundred aerial or visit our website at www.matchmaster.com.au
Thanks for watching